Large Equipment Booths
Heating Systems
1 - 20" X 25" Supply Filters
2 - Indirect Gas-fired Heater
3 - Recirculaton Blower
4 - Air Return Box
5 - 20" X 20" Return Filter
6 - Air Return Box
7 - Transition
2 - Indirect Gas-fired Heater
3 - Recirculaton Blower
4 - Air Return Box
5 - 20" X 20" Return Filter
6 - Air Return Box
7 - Transition
Recirculating heaters are designed for 80% thermal efficiency for indoor application with gravity venting. They are certified to use with natural or propane gas, in sizes ranging from 75,000 to 400,000 BTU input.
Heater Standard Features:
Aluminized steel heat exchanger
Aluminized steel burners with stainless steel insert
120-volt supply voltage
24-volt control voltage transformer
High limit safety cutout
Single-stage combination gas valve
Side access for burners and controls
Horizontal or vertical flue discharge\
Manual match-lit pilot\
Energy cut-off device\
Blocked vent shut-off system
DR-1000 Recirculation Heater Unit
Horizontal Heating Unit with 300,000 BTU, 60 degree F temperature rise, Indirect natural gas fired heat exchanger including all gas controls, electric ignition pre-wired,
Duct Thermostat
Recirculation Duct work designed for the drying enclosure
Purge Timer Control Panel NEMA-12 with necessary
switches
Assembly hardware for the heater and ductwork
Rail Mounted unit for easy installation
Inlet register with filter frame
Discharge register
REQUEST A QUOTE | CONTACT US
Spray Systems, Inc. 1363 East Grand Avenue Pomona, CA 91766 Toll Free: (800) 736-6944
Phone: (909) 623-6944 Fax: (909) 622-6267 Email: sales@spraysystems.com
Copyright © 2001 Spray Systems, Inc. All Rights Reserved.
Heater Standard Features:
- Orifices for natural gas
DR-1000 Recirculation Heater Unit
Horizontal Heating Unit with 300,000 BTU, 60 degree F temperature rise, Indirect natural gas fired heat exchanger including all gas controls, electric ignition pre-wired,
- AGA/CGA certified.
The above heater unit is designed to be mounted on top of the DR-1000 Drying Room. The heater is designed to maintain the booth enclosure to approximately 120-140 degrees F, accelerating drying time and thus increasing production. After the heater is shut off, the blowers will continue to run to purge the enclosure.
REQUEST A QUOTE | CONTACT US
Spray Systems, Inc. 1363 East Grand Avenue Pomona, CA 91766 Toll Free: (800) 736-6944
Phone: (909) 623-6944 Fax: (909) 622-6267 Email: sales@spraysystems.com
Copyright © 2001 Spray Systems, Inc. All Rights Reserved.
